Weight Transmitter DAT 100 RS485

DAT 100 RS485

The DAT 100/RS485 product is a weight transmitter which gurantees high performance and long-term reliability. Its small width makes it possible to position a large number of transmitters inside the electrical automation panels. DAT 100/RS485 weight transmitter has an interface with intrinsically safe barriers for use in hazardous areas. It has two red status LEDs, 3 mechanical buttons behind the red door and screw terminal blocks.

Further Information

Technical Specifications in PDF

PVS: 37/2015

Download    Technical Manual

Technical Specifications

Measuring range: –4 ÷ +4 mV/V
Input sensitivity: 0.02 µV/count
Full scale non-Linearity: < 0.01%
Gain drift: < 0.001% FS/°C
Display: 5 digit, red LED (7 segments), h 7 mm
A/D Converter: 24 bit
Internal Resolution: > 16.000.000 points
Trasducer input voltage: 4 V (max 4 cells 350 Ohm)
Frequency signal acquisition: 4 ÷ 123 Hz
Visible resolution (in divisions): 999999
Divisions value (adjustable): 0.001 ÷ 50
Temperature range: -10 ÷ +50°C (max umidity 85% without condensation)
Storage temperature: -20 ÷ +60°C
Filter: 0.2 ÷ 25 Hz
Logic output: 2 Solid-state relays, (maximum load 24 Vdc / 100 mA each)
Logic input: 2 optoisolated 24 Vcc PNP (External voltage)
Serial port: RS232C half duplex with ASCII or Modbus RTU protocol, RS485 full duplex with ASCII or Modbus RTU protocol
Power supply: 24 V c.c. ±10% – power 2 W
Regulatory compliance: EN61000-6-2, EN61000-6-3 for EMC; EN61010-1 for electrical security
Baud rate: 2400 ÷ 115200 adjustable
Transmission distance: 15 m (RS232); 1000 m (RS485)

Certifications

  • UL
  • EAC

Related products